System settings#

System settings can be found at: Settings -> System settings.

Backup#

FX-3000-X has a memory card installed. Memory card stores backups. The SD memory card will hold 10 backups and the oldest backup is deleted automatically.

  • Backup folder contains: Bin, Data and www.

  • SD cards minimum size is 512 MB.

  • Backups are automatically created once a week during the night.

  • Creating backup can be forced by pressing button “Backup” in Settings > System settings.

  • Backup folder may contain uncompleted folders such as “DeletingThisFolder” or “BackupInProgress”. These folders will be deleted automatically by FX-Controller.

Warning

Do not upload excess symbols to the FX-controller. Upload only symbols used in the project. Huge amounts of excess symbols could slow down the FX-controller.

Device settings#

Device settings. Can be found from Settings -> System settings -> Device settings

../../_images/System_settings1.png

  1. Device name: Name can be 29 letters long.

  2. Session time limit: After this time user will be logged out automatically.

  3. SSH and SFTP password. It’s recommended to change this password after installing the FX-3000-X.

  4. WebVision authentication key: Key is used in communication between FX-3000-X and WebVision. Note! This has to be the same in both FX-3000-X and WebVision. Authentication key has been used in global points before version 11.42.00

System status#

System status information can be found from Settings -> System settings -> System status

In beginning of the page there is general information about FX-3000-X.

../../_images/System_settings6.png

  1. FX-3000-X can be rebooted by executing reboot device. Rebooting boots the whole operating system.

  2. GSM modem can be used to send alarms. Singnal level gets a value between 0-99.

    • 0 = Error

    • 1-31 = Signal level, a bigger value means a better signal.

    • 99 = No signal at all.

  3. Mobile network

  • USB dongle connected = Shows if USB dongle is connected.

  • Mobile network status = Show if mobile network is active or not.

  • GSM network = Network strength 1(LOW).. 31(High).. 0 = No network

    • 1 = Low

    • 31 = High

    • 0 = No network

  • RX/TX total(kb) = Indicates how much data has been transfered.